88 lines
2.0 KiB
Arduino
88 lines
2.0 KiB
Arduino
/*
|
|
SD card basic file example
|
|
|
|
This example shows how to create and destroy an SD card file
|
|
The circuit:
|
|
SD card attached to SPI bus as follows:
|
|
** MISO - pin 4
|
|
** MOSI - pin 7
|
|
** CS - pin 5
|
|
** SCK - pin 6
|
|
|
|
created Nov 2010
|
|
by David A. Mellis
|
|
modified 9 Apr 2012
|
|
by Tom Igoe
|
|
|
|
This example code is in the public domain.
|
|
|
|
*/
|
|
|
|
// This are GP pins for SPI0 on the Raspberry Pi Pico board, and connect
|
|
// to different *board* level pinouts. Check the PCB while wiring.
|
|
// Only certain pins can be used by the SPI hardware, so if you change
|
|
// these be sure they are legal or the program will crash.
|
|
// See: https://datasheets.raspberrypi.com/picow/PicoW-A4-Pinout.pdf
|
|
const int _MISO = 4;
|
|
const int _MOSI = 7;
|
|
const int _CS = 5;
|
|
const int _SCK = 6;
|
|
|
|
#include <SPI.h>
|
|
#include <SD.h>
|
|
|
|
File myFile;
|
|
|
|
void setup() {
|
|
// Open serial communications and wait for port to open:
|
|
Serial.begin(115200);
|
|
|
|
Serial.print("Initializing SD card...");
|
|
|
|
// Ensure the SPI pinout the SD card is connected to is configured properly
|
|
SPI.setRX(_MISO);
|
|
SPI.setTX(_MOSI);
|
|
SPI.setSCK(_SCK);
|
|
|
|
if (!SD.begin(_CS)) {
|
|
Serial.println("initialization failed!");
|
|
return;
|
|
}
|
|
Serial.println("initialization done.");
|
|
|
|
if (SD.exists("example.txt")) {
|
|
Serial.println("example.txt exists.");
|
|
} else {
|
|
Serial.println("example.txt doesn't exist.");
|
|
}
|
|
|
|
// open a new file and immediately close it:
|
|
Serial.println("Creating example.txt...");
|
|
myFile = SD.open("example.txt", FILE_WRITE);
|
|
myFile.close();
|
|
|
|
// Check to see if the file exists:
|
|
if (SD.exists("example.txt")) {
|
|
Serial.println("example.txt exists.");
|
|
} else {
|
|
Serial.println("example.txt doesn't exist.");
|
|
}
|
|
|
|
// delete the file:
|
|
Serial.println("Removing example.txt...");
|
|
SD.remove("example.txt");
|
|
|
|
if (SD.exists("example.txt")) {
|
|
Serial.println("example.txt exists.");
|
|
} else {
|
|
Serial.println("example.txt doesn't exist.");
|
|
}
|
|
}
|
|
|
|
void loop() {
|
|
// nothing happens after setup finishes.
|
|
}
|
|
|
|
|
|
|