diff --git a/dist/iidxhook-20.conf b/dist/iidxhook-20.conf
deleted file mode 100644
index d5ed89e..0000000
--- a/dist/iidxhook-20.conf
+++ /dev/null
@@ -1,38 +0,0 @@
-# Run the game in a framed window (requires windowed option)
-gfx.framed=false
-
-# Software limit the frame rate of the rendering loop in hz, e.g. 60 or 59.95 (0.0 = no software limit)
-gfx.frame_rate_limit=0.0
-
-# Patch the GPU device ID detection (leave empty to disable), format XXXX:YYYY, two 4 digit hex numbers (vid:pid). Examples: 1002:7146 (RV515, Radeon X1300), 1002:95C5 (RV620 LE, Radeon HD3450)
-gfx.pci_id=1002:7146
-
-# Run the game windowed
-gfx.windowed=false
-
-# Windowed width, 0 for default size
-gfx.window_width=0
-
-# Windowed height, 0 for default size
-gfx.window_height=0
-
-# Up-/downscale the back buffer's width. This does not change the game's rendering resolution but scales the final frame. Use this to target the native resolution of your monitor/TV, e.g. to avoid over-/underscan, bad image quality or latency caused by the monitors internal upscaler. 0 to disable this feature. Must be set in combination with the corresponding height parameter.
-gfx.scale_back_buffer_width=0
-
-# Up-/downscale the back buffer's height. This does not change the game's rendering resolution but scales the final frame. Use this to target the native resolution of your monitor/TV, e.g. to avoid over-/underscan, bad image quality or latency caused by the monitors internal upscaler. 0 to disable this feature. Must be set in combination with the corresponding width parameter.
-gfx.scale_back_buffer_height=0
-
-# Filter type to use for up-/downscaling the back buffer. Only used if scaling feature was enabled by setting the scaling width and height parameters. Available types: none, linear, point (refer to D3DTEXTUREFILTERTYPE  for explanation).
-gfx.scale_back_buffer_filter=none
-
-# Forced refresh rate, -1 to not force any (try 59 or 60 if monitor check fails to lock on high refresh rate monitors)
-gfx.forced_refresh_rate=-1
-
-# D3D9 device adapter (monitor), -1 to use default, 0, 1, 2 etc. to use specified adapter
-gfx.device_adapter=-1
-
-# Disable card reader emulation and enable usage of real card reader hardware on COM1 (for games supporting slotted/wavepass readers)
-io.disable_card_reader_emu=false
-
-# Disable ezusb IO emulation and enable usage of real ezusb1/2 IO hardware
-io.disable_io_emu=false
\ No newline at end of file